Your cart is currently empty!
Author: Halfling13
Minimal Updates
—
by
As our housing plans go into high gear, the number of updates will continue to drop temporarily. This is partially due to far too many things going on, as well as basic lack of availability of computers. Over the next few weeks, there will be a lot of changes on our home front, then a…
Gencon
—
by
Sadly, thanks to ongoing Covid concerns, Gencon has announced the cancellation of the 2020 convention. Although this no longer directly impacts our local gaming group (we had previously cancelled), I am sure this is disappointing for many who had still held out hope. No doubt it will be a major impact to the Indianapolis tourist…
Halting the video content
As part of our house-swapping efforts, my time has become very limited. This, along with the very low views on any of the content, has convinced me that it is a rather large amount of work for a very small benefit. As such, as the current YouTube posting come to an end, I am going…
Life changes
—
by
So after a long waiting and preparation period, we are finally moving forward with plans to relocate to a new home. For this round, we are opting to build, in a location admittedly only a few blocks away from our current location – but it will cause a lot of disruption over the next 6…
PrusaSlicer profiles
—
by
As commented before, I have been working on converting to using PrusaSlicer for my 3d printing and slicing. This has the advantage of a stock, supported configuration for the i3MK3s. However, it has required quite a bit of adjustments to the configuration, in order to run “well”. I continue to have challenges with supports, especially…
Age of Ashes, Chapter 2, Episode 5
Episode 5 of the 2nd Chapter (Cult of Cinders) of our Age of Ashes campaign is being released now on YouTube. If you are a supporter on Patreon, you can view the content up to two weeks early. Otherwise, the content will be released in pieces over the next couple of weeks. This particular session…
PrusaSlicer
—
by
Experimenting a bit with my 3d printing slicer program, and rapidly becoming a convert to the PrusaSlicer option. Not only is it fully supported and the “official” answer for my i3 MK3s Prusa printer, but it has some advances in the recent version that my prior option (Simplify3D) simply doesn’t have. In particular, the latest…
Gencon 2020
—
by
With regret, we ended up cancelling our group plans for Gencon 2020 this year, thanks to ongoing concerns over Covid. Although the state of Indiana and the Gencon organization has not officially cancelled the event, we felt it was prudent to make alternate plans. Best case projects are aiming for a mid-May “restart” to various…