Category: 3d Printing

  • True-Tiles practical application

    True-Tiles practical application

    —

    by

    Halfling13

    With a painted and otherwise complete set of True-Tiles in hand, we had our next session of Pathfinder on Sunday, reaching the climax of Chapter 4 of the Rise of the Runelords.  Unfortunately, I discovered I had not actually printed a large enough set, I still had several more to do before having enough to…

  • Update on gaming schedule

    Update on gaming schedule

    —

    by

    Halfling13

    Running a bit late today, thanks to an overly busy schedule with work.  Falling behind with the video sessions for the gaming, thanks to my distractions with 3d printing, but managing to successfully print a lot of material.  In particular, I should have enough True-Tiles for the upcoming Pathfinder session on Sunday, which should go…

  • True-Tiles, second batch

    True-Tiles, second batch

    —

    by

    Halfling13

    In preparation for the second wave of my True-Tiles printing, I have been batch printing a lot of bases, while I wait for the little round magnets to arrive today.  I believe I will need more square bases to fully re-finish the prior tiles, but I will be doing those once I have fully tested…

  • 3D Printing viewing

    3D Printing viewing

    —

    by

    Halfling13

    I doubt I had anyone actually bother to watch my 3d printer in action, and if you had, then you likely found that the performance was certainly lacking.  As an alternative, I have now instead configured it to run through my YouTube Live channel, with a streaming option instead.  This provides far better quality, which…

  • Skulls

    Skulls

    —

    by

    Halfling13

    With the acquisition of the 3d Printer, my son’s big ask was for a prop for use during our gaming sessions.  Since he is currently playing a Necromancer in our Pathfinder campaign, he of course wanted a skull to show off.  And since I am always up for a challenge, we opted for not just…

  • Printing and more printing

    Printing and more printing

    —

    by

    Halfling13

    Finished up a second batch of tiles on the printer while I was out of town this week, then upgraded the little Raspberry Pi computer that manages the printer itself.  Now I should have sufficient space to at least do a timelapse of future prints, and potentially even stream live to YouTube.  Still a bit…

  • True-Tiles Batch 1 painting

    True-Tiles Batch 1 painting

    —

    by

    Halfling13

    Managed to take time to paint up the first set of True-Tiles, consisting of 10 doors, 4 flat tiles, 5 single wall tiles and 5 corner tiles.  Total time, about 4 hours.

  • 3D Printing View Port

    3D Printing View Port

    —

    by

    Halfling13

    Are you mesmerized by an active 3D printer like I am?  Can you stare for hours watching the robotic arm move back and forth as it slowly builds a model millimeter by millimeter?  If so, then I have a fun little new option with my printer – a live feed that runs pretty much all…