Category: 3d Printing
-
Revisiting the Trophy
Several months ago, I posted about my project to craft and create a trophy for our annual Magic the Gathering tournament. I managed to revisit this project this week, while I was spending time for work in Toledo. Didn’t end up having as much time as I had hoped (we had a big outage to…
-
The Dice Box
As I continue to experiment and attempt resin molding, and fiddle and tune the 3d printer, I managed to finish a single full usable dice box, in my preferred copper PLA filament. Its not the ideal design (I have a version with a Runelord’s Sihedron Rune in the top), but the lid and base are…
-
Molding Fail
Apparently, I made a mistake with the resin. After a bit of math, I had estimated fairly closely the amount of resin mix required to fill the mold – right at 1 cup total. Mix the material, add coloring, stir for several minutes, slowly pour into the mold. After several minutes of slow pouring, I…
-
Experiments in molding – part 2
We finished the second half of the first attempt at a mold on Tuesday, and managed to de-mold the forms that evening. New lesson learned – if you don’t spray a sealant, the new silicon bonds with the old. Thus I had to cut a new seam in the mold, to remove the original. Fortunately,…
-
3d Printer Nozzle issues
Over the last week, I have been having new challenges with the 3d Printer, as I have been trying to print rather large parts. Initially, I could not get the filament to adhere, or it would be splotchy and rough at different sections. As usual, a lot of this was a matter of constantly tuning…