• We did plan on having our Pathfinder session this last weekend, to resolve the mystery of the fate of the group following the cliffhanger of the prior session.  Unfortunately, my son’s football game got rained out on Saturday, and rescheduled for Sunday, right in the middle of our usual schedule (and several of our players […]

  • Finally managed a successful casting in resin, though I am strongly debating whether it is a practical option or not.  Between the cost of molding and the resin itself, and then the cleanup after, it isn’t a very practical solution for this type of item.  In truth, that is no doubt why CNC wood cutting […]

  • As I continue to experiment and attempt resin molding, and fiddle and tune the 3d printer, I managed to finish a single full usable dice box, in my preferred copper PLA filament.  Its not the ideal design (I have a version with a Runelord’s Sihedron Rune in the top), but the lid and base are […]

  • Apparently, I made a mistake with the resin.  After a bit of math, I had estimated fairly closely the amount of resin mix required to fill the mold – right at 1 cup total.  Mix the material, add coloring, stir for several minutes, slowly pour into the mold.  After several minutes of slow pouring, I […]

  • We finished the second half of the first attempt at a mold on Tuesday, and managed to de-mold the forms that evening.  New lesson learned – if you don’t spray a sealant, the new silicon bonds with the old.  Thus I had to cut a new seam in the mold, to remove the original.  Fortunately, […]

  • Over the last week, I have been having new challenges with the 3d Printer, as I have been trying to print rather large parts.  Initially, I could not get the filament to adhere, or it would be splotchy and rough at different sections.  As usual, a lot of this was a matter of constantly tuning […]

  • Expanding my efforts with 3d printing, by branching out into silicon molds and epoxy replication.  First attempt is a rather large project to attempt to duplicate a set of rpg dice cases I am working on, instead of having to print each set.  So far, this is just the first of two parts, and the […]

  • Since we had to reschedule the start of our Shadowrun campaign, I used the opportunity to try out the second edition of Star Wars X-Wing with my son.  The closest comparison we have is Armada, which although Star Wars, plays much differently.  The main advantage we found is that the game runs much faster, turn […]

Disclaimers and Legalese

This website uses trademarks and/or copyrights owned by Paizo Inc., which are used under Paizo’s Community Use Policy. We are expressly prohibited from charging you to use or access this content. This website is not published, endorsed, or specifically approved by Paizo Inc. For more information about Paizo’s Community Use Policy, please visit paizo.com/communityuse. For more information about Paizo Inc. and Paizo products, please visit Paizo.com.